| At risk of someones ire for asking an already asked question
(4887.0),:
Will Polycenter Network Manager 200/400 run on an FDDI based
VAX workstation? If so, are there any functionallity problems?
If not, when if ever will it?
I am asking this again as a separate note rather than a reply
to 4887.0 because that was a month ago and nobody replied!
As with 4887's writer, I also have a customer who wants to do
this!
|
| I have moved this reply here, since people see new replies in the same
way as new notes, and posting new notes clutters up the conference.
I believe that the reason there has been no answer is that nobody here has
tried to run on a purely FDDI station.
The only issue I know of off hand is that in order to generate UIDs,
Polycenter 200 relies on the uniqueness of an Ethernet address.
But I believe that FDDI has an equivalent MAC address, right?
-- Erik
|
| The short answer to this question is that FDDI controllers are
not offically supported by the MCC EA routines, but there are some
workarounds.
See notes 4734, 4783, 5045 and 5049 for discussions on workarounds
and problems associated with using MCC from and FDDI managment station.
-Bob
|