| Title: | DECmcc user notes file. Does not replace IPMT. |
| Notice: | Use IPMT for problems. Newsletter location in note 6187 |
| Moderator: | TAEC::BEROUD |
| Created: | Mon Aug 21 1989 |
| Last Modified: | Wed Jun 04 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 6497 |
| Total number of notes: | 27359 |
I'll probably be made to look silly for asking this, but here goes:
On Phase 4 Line Traffic Reports, why do the Total KBytes and Total
KData_blocks not equal the sums of the In and Out figures for DDCMP
circuits, whereas they do for Ethernet circuits?
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1679.1 | Depennds on the mode of the line | TOOK::ANWARUDDIN | Anwar | Thu Oct 24 1991 17:18 | 8 |
On Phase 4 Line Traffic Reports, why do the Total KBytes and Total
KData_blocks not equal the sums of the In and Out figures for DDCMP
circuits, whereas they do for Ethernet circuits?
>> In the case of the DDCMP Line, Total Kbytes & Total Kdatablocks are
>> the sum of the maximums of (Out and In) figures if the line is full
>> duplex. That's probably the reason they don't equal sums of Ins & Outs.
| |||||
| 1679.2 | perhaps better documented...? | NYFDIN::SAMBAMURTY | Raja | Mon Feb 24 1992 14:12 | 8 |
we ran into the same problem recently. It would be nice if this were to
be documented, for the benefit of people like to me (it wasn't obvious
to me when I looked this over, and the manual has an example for a
ethernet line where it does add up). thanks
reg
raja
| |||||