| When in diagnostic mode, the drivers are started by the >>>CONFIG command.
When in basic mode, the drivers are started and stopped by >>>SHOW DEV.
However, in diagnostic mode, the idea is just to start the drivers up and
leave them running until a >>>SHUTDOWN. The >>>SHOW DEV just lists the
devices but does not start nor stop the drivers in DIAG mode.
<<< Note 1209.0 by JOBURG::HARRIS >>>
-< AS8400 V4.8-6 Diag bugs ?? >-
Is it a bug ? AS8400 V4.8-6
1.When setting the mode of the console to "DIAG" and doing "Sho dev"...
No devices are reported.
2. When setting the mode to Advance or Diag and doing Sho D*, I am
seeing only about 5 lines of D.... This happens on 8 AS8400
Any info?
Regards Ivan
|