|
Hi Paul,
>I have a customer that has a 56kb link from the U.S to Ireland
>and about every two to three months the link comes up with a status of
>serial 0 up line protocol down on the Ireland side. the line checks out
>with Telco
What type of Network link is it? and what is the DCE device connected?
>the way the customer gets it back is to reseat the module in the hub.
This seems like a signaling problem from the DCE end. Reseating the
DECbrouter is probably just reseting the signal states. I'd suspect
the DCE device. You may try plugging the DECbrouter into a standalone
power supply just to see if it could be HUB based power related but
I'd be supprised if this was the case.
>the unit is a DECbrouter 90 T1 running ver 9.14 and
>9.1 firmware. Has anyone had this problem? Any help Would be greatly
>appreciated.
I am not aware of any 9.14 specific problems but I do need to see the
configuration of the router as well as know more about the Network config
specifically with regards to the Telco end, type of CSU/DSU and config.
o
/\_.
Neil Sheehan _-\-_|
NPS/NSTG Router Support (*)/ (*)
|