|
> Q1 : What is the recommented set up ? (PAB, SLS ?)
SLS provides no client services for WNT. Archive/Backup aka ABS or
PAB is your best bet.
> Q2 : How do I specify remote tape drive in both ABS and STORAGE
commands ? (node::MKA300: or node::TZ887 as specified in TTI config)
Either specification will work. I think you'll find the setup less
confusing if you avoid use of the RDF characteristic name and just use the
device name.
> Q3 : Can I do STORAGE LOAD node::TZ887 VOLUME volumeid ?
Preferably, use the commands:
$ STORAGE SELECT/DRIVE=node::MKA300: MYDRIVE
$ STORAGE LOAD MYDRIVE volumeid
> Q4 : How do I use DCL BACKUP command on RDF tape ?
$ BACKUP filespec MYDRIVE:saveset-name/SAVE
> Q5 : I suppose serving disk to remote nodes via RDF is supported as it
is one of the question asked during installation. What is the benefit
of having RDF disk served vs DECNET/PROXY ? Can I perform BACKUP/IMAGE
on RDF disk ?
Contact Touch Technologies, Inc. (TTI) regarding RDF support for
serving disk drives. SLS/MDMS does not support this feature of RDF.
The two questions asked during SLS/MDMS installation are intended only
to find out if the node will use remote tape drives and if it will serve
tape drives.
Hope this helps,
Marty.
|