[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

3046.0. "DECPM-M Langroup switch problem" by FRSCS::AGOERG () Fri Dec 08 1995 14:07


		Hi Folks,

we have discouvered a problem with configuring a PORTswitch900CP V2.1.0 
using HUBwatch 4.1 (MS-Windows version). Running HUBwatch, you can enter 
the Portswitch section and select for the different ports one of the six 
possible groups. But, and that's the joke, we were not able to put a port 
back to group one in the matrix. Also a powercycle of the module was 
unsuccessfull, whe had to reset it to factory settings. Since then, all 
Ports are reconnected to group one. We can choose again the groups, 
switching between the groups two to six is problemfree, but there is no
possibility to go back to group one. 

Any comments, workarounds or solutions?

Best greetings, Alexander Goerg @FRS
T.RTitleUserPersonal
Name		DateLines