| I would like to load the flash rom firmware to a Decbridge 90
that i use in my lab. To do this i need this file, write ?
Or am i doing something wrong ?
This is the article found on Tima.
Loading Flash Rom Firmware to a DECbridge 90 / 90FL
DESCRIPTION:
Reset the DECbridge 90 to factory defaults by pressing the recessed
button
at the bottom part of the faceplate. Press the button and then power up
the
bridge simutaniously.
To load Flash Rom Firmware to the DECbridge 90/90FL execute the
following
commands under NCP:
NCP> SET NODE <address> NAME <name> HARDWARE ADDRESS -
08-00-2B-xx-xx-xx SERVICE CIRCUIT <ethernet circuit> LOAD FILE -
<dir:filename.ext>
NCP> LOAD NODE <name>
address = a DECnet address not currently in use, ie. 63.123
name = a DECnet host name not currently in use, ie. DB90
ethernet circuit = ie, SVA-0, BNA-0, etc...
dir:filename.ext = filename of firmware, ie, FLASH.EXE
Another article say that i could get this file at the location
below but i didn'd find it.
KALI::SYS$PUBLIC:[WGB.FIRMWARE.vvv]FLASH.EXE
Where is it ?
Thanks,
Henrique.
|