[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

2996.0. "Problem launching Hubwatch from Polycenter Netview" by CSC32::B_LEWIS () Wed Nov 22 1995 13:08

I have a customer that gets the following message when launching Hubwatch
from Polycenter Netview.

Getting error message on launch as follows.

      In DX console  (error display for Polycenter)

        File:/user/capitol_ou/reg
             /c/hubwatch_reg
        Line:50
             Error unknown field "is dechub"


Any ideas about this message, if anyone needs more I can contact the customer.

 Brad Lewis US/CSC
T.RTitleUserPersonal
Name
DateLines
2996.1Someone edit the file?NETCAD::FORINOMon Nov 27 1995 15:5213
    First off - is the HUBwatch application entry enabled (not greyed out)
    for the device you want to launch HUBwatch against.  If it is greyed
    out, then read the release notes about what must be done to enable
    HUBwatch.  If it is not greyed out check line 50 in the registration
    file - I believe it is the selection rule line and should have an
    entry like
    
                SelectionRule isDEChub;
    
    I'm wondering if someone may have edited the file and changed isDEChub
    to what the error is giving you.  That could be reason for the error.
    
    						John
2996.2more infoCSC32::D_PERRINFri Dec 01 1995 21:2316
    More info from the customer:
    
    He says that Hubwatch by itself starts and runs
    fine. It's when he tries to start up Polycenter Netview that he gets
    the "unknown field" error. So he never sees Hubwatch either:
    
        1. as a pull-down application selection under the Monitor
                       entry in the Menu Bar
        2. as a pull-down application selection under the Monitor
                       when hitting MB3 over a symbol in the map
    
    He did NOT edit the hubwatch_reg file. I'm having him fax me 
    this file. Does anybody have a pointer to one of these that I can
    look at? At the moment we don't have a Unix box to install this
    on.