Conference netcad::hub_mgnt

2350.0. "DECbridge/DECagent/NDU Firmware Kit available" by ROGER::GAUDET (Because the Earth is 2/3 water) Wed Jun 07 1995 12:36

A new kit has been developed to provide the means to update devices that do not
support TFTP loads, e.g. the DECbridge 90/90FL and DECagent 90 running V1.1 and
earlier firmware.  Since these devices cannot be loaded using the new HUBloader
utility, a new kit has been developed to provide the firmware and tool to load
these devices, all in one package.

The kit is called the DECbridge/DECagent/NDU firmware kit.  It includes the
DECbridge 90/90FL V3.9 firmware, the DECagent 90 V3.0.0 firmware, the
denmalod.sys file for performing the two-step load of the DECagent 90 (if you're
running V1.0 firmware), and DECndu Plus for DOS.  Also included are the release
notes for both firmware images.  You should read the release notes for the
DECagent 90 for important information on upgrading and preserving the
configuration information in your DECagent 90.

The kit is available only on the DOS platform.  It consists of a single DOS
diskette.  This diskette is included when customers order HUBwatch on any
platform.  It is essentially part of the firmware kit that is provided with
HUBwatch.

For you network folks, I have also provided network access to the kit.  It can
be copied from the following location:

	NETCAD::PROJ$722:[ONEHUB.RELEASE.FIRMWARE.V4_0.AGENT_BRIDGE_NDU]

Check out the README.TXT file in that directory for instructions on how to build
the diskette.  This file also contains the release notes for the kit.

As always, drop me a note at NETCAD::GAUDET if you have any questions.

...Roger...