| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
Maybe somethings wrong in my mind. But how can we do an upgrade of a DECconcentrator 900. If there's just one DECcontrator900 in dechub900 and a DR900.It's not possible to connect the DC900 to an ethernet channel in the backplane (It is ?). And the system for upgrade DC900 is connect to the dr900 (there is no possible ethernet communication between DR900 and DC900 )
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 2154.1 | Hub-assisted load | ROGER::GAUDET | Because the Earth is 2/3 water | Thu Mar 30 1995 11:46 | 11 |
Use the hub manager's setup port menu selection "Downline Upgrade" to perform a hub-assisted load to that device. The load will take place over the Ethernet through the IP services module and into the hub manager, then from the hub manager over the backplane management channel to the device. No need to have an FDDI connection to the concentrator. You need to setup an in-band IP address for the hub with the DR900 as the IP services module or an out-of-band IP address, then make sure you have a connection to the load host. ...Roger... | |||||
| 2154.2 | pb with PC | ATYISA::JACQUOT | Thu Mar 30 1995 14:57 | 8 | |
thanks for your answer , in fact I ask question cause I upgrade with a
portable PC and upgrade works fine with DEChub900, DECbridge900MX, some
of DR900 and not at all with DC900. After your answer I try with an
another PC and now all is ok, so my PC has probably some trouble with
its ethernet interface
ERic
| |||||