Conference netcad::hub_mgnt

985.0. "Decserver90l in Dechub900 problem.." by PADNOM::PEYRACHE (Jean-Yves Peyrache Country Support Group France) Fri May 13 1994 16:00

 
 hi all,

  Dechub900 V2.3 Decagent V2.0-16 Decbridge90 V3.1 Hubwatch for Windows T2.1.0

 
 i have some trouble to manage a Decserver90l plugged in Dechub900

 i have in my favorite Dechub900 in slot 1 a Decserver90l V3.1
                                    slot 2 a Decbridge90  V3.1
                                    slot 3 to 8 a bunch of DEcrepeater900tm

 somewhere in my network in have hooked a Decagent90.

 
 i have entered 4 agent in agent file 

  1 / for Dechub900
  
  2 / for Decagent90

  3 / For Decbridge90 with Ip address of Decagent90

  4 / for Decserver90 l with ip Adress of Decagent90

 i have entered 2  community in my decagent90




 now my problem:
  
 In hubview on Dechub900 "double-click" on Decagent90 works fine
 In Hubwiew on Dechub900 "double-click" on Decbridge90 works fine
 In hubwiew after entered in add module selected a Decserver90l ,module appears
 go from unkown type to Decserver90l type ,but if i "double-click on it"    
sometimes few informations appears (when clicking on a port) sometimes nothing  
 appears, module is selected but any windows appears...


  if anybody have some ideas/sugestions/configurations hints ???

 thanks

 Jean-Yves

    
     Jean-Yves,
    
    If the DECagent 90 is not in the same DEChub900 as the DECserver
    90L, then you need to create an 8-slot-hub DECagent 90 community
    (not a standalone community) for the DECserver 90L. Add the DECserver
    90L to the same slot of this community as the DECserver 90L occupies
    in the DEChub 900. You must also have an entry in the Agent list box
    (HUBwatch Agents File) for the DECserver 90L, which includes the 
    terminal server's community, MAC address, and DECagent 90's IP address.
    
    Hope this helps,
    Bob

 ok i try it

 Jean-Yves