Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
Moderator: | NETCAD::COLELLA DT |
Created: | Wed Nov 13 1991 |
Last Modified: | Fri Jun 06 1997 |
Last Successful Update: | Fri Jun 06 1997 |
Number of topics: | 4455 |
Total number of notes: | 16761 |
I am having problems with the graphs on PROBEwatch for Windows. They are as follows: Etherstats Graph: The window opens up, but there is no graph. The message at the bottom of the window reads "No domain installed". Funny message... I got this graph window to open by clicking on the graph buttom in the ALL domain window. WHat does this mean? Long-Term and Short-Term Graphs: The windows open up but there is no graph. There is also no mesage at the bottom of the window. The "Buckets:" and "Sample Interval:" fields are empty, almost as if the graph facility has died as soon as it put up the window and a little verbage. Regards, Mark
T.R | Title | User | Personal Name | Date | Lines |
---|---|---|---|---|---|
981.1 | Could someone sum up all problems in ONE notes entry? | OSLACT::BJORN | Fri May 13 1994 08:24 | 43 | |
981.2 | Half hearted Windows! | WOTVAX::64021::Tim_Banks | Network Mercenary | Wed May 18 1994 12:26 | 19 |
RE: point 4 in -1, see 979, put hosts file in IP stack directory for Pathworks (or wherever your IP stack is located) that works so it appears. I have seen all the same problems described earlier, as well as when a window is launching it half writes to the screen, but leaves big holes, and then finishes up later. The whole package seems slow, but that could be due to the network delay to the USA, and the heavy traffic on the probes segment. My PC is a 486 25Mhz with 8 Meg memory and 300Mbs disk. Also, I have found that when running the software for the first time after powering my PC on, I can't launch a domain view, or anything much else. If I quit from the application, and then re-open it all works OK. Thanks Tim | |||||
981.3 | KAOFS::S_HYNDMAN | Acronym Decoder Ring Architect | Wed May 18 1994 16:39 | 8 | |
I have also noticed that menu selections do not work the first time you enter Probewatch, even the exit will not work. I kill the window for Probewatch and restart and then the menu items work. Scott |