[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:	DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:	Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:	NETCAD::COLELLADT

Created:	Wed Nov 13 1991
Last Modified:	Fri Jun 06 1997
Last Successful Update:	Fri Jun 06 1997
Number of topics:	4455
Total number of notes:	16761

697.0. "Redirection of DEChub 900 Setup Port" by GIDDAY::KO (Anthony Ko @SNO - NSW Consulting, Australia) Mon Feb 07 1994 04:43

Hi all,

As I believed that the Setup Port of our DEChub 900 was re-directed to somewhere
previously by someone, nothing (not even the Hub Manager's menu) is displayed on
my terminal screen after powering up the hub. How can I reset the Setup Port or
the Hub Manager's attributes to factory settings? Replacing the Hub Manager ??

Thanks & Regards,
Anthony

T.R	Title	User	Personal Name	Date	Lines
697.1	Re-directed Console	LEVERS::DRAGON		`Mon Feb 07 1994 11:11`	8
	Anthony, The DEChub 900 Setup Port console re-direct should not survive a power-cycle of the DEChub 900. Maybe try checking the terminal settings, cables, etc.. Bob
697.2	That's strange!	GIDDAY::KO	Anthony Ko @SNO - NSW Consulting, Australia	`Mon Feb 07 1994 21:26`	5
	Bob, But I used the same cable and terminal connecting to the port 1 of a DECserver 900TM which attached to that DEChub 900 and messages were displayed on the screen.
697.3	Different Baud?	LEVERS::DRAGON		`Tue Feb 08 1994 10:56`	8
	Anthony, Could be that someone set the Setup Port's baud rate if your running a T3.x version of MAM code (ie 1200, 2400, 4800, 9600). You might want to try those settings. Bob
697.4		QUIVER::SLAWRENCE		`Mon Feb 14 1994 14:55`	11
	You should not be running a T3.X version, of course. The terminal should be set to 9600bps 8 bits, 1 stop bit, No parity If you power cycle the hub you should get the hub menu on the screen. No console state (redirect or event logging) is retained through any reset, including power cycle. If you don't, check to make sure that the MAM diags are passing (does the display show a hex failure code?) and the usual checks for the cables and the above settings.