Conference azur::mcc

3395.0. "V1.2 Exporting problem" by PANIC::HOARE () Tue Jul 21 1992 13:25

    I would like to view the information that I have recorded historically in 
    the MIR using Mcc V1.2. This information comprises line and circuit 
    information derived from six routers at 15min intervals over a period of 
    about three days. When I do a "show recording", I am informed that the
    polling has been successful.
    
    So far so good I believe, however I am having trouble inspecting this
    information to ensure that I have good data.
    
    I have been exporting a three or four hour sample of the information
    using the EXPORT facility in the menu and recieved notification that
    exporting has been successful. I exported both line and circuit
    information over the same time interval to ensure that I had sufficient
    information to be produced on a graph.
    
    I am certain that the Mcc Reports setup is correct and that MCC_EXPORT
    and DICTIONARY are defined properly and was able to produce graphical
    output from an earlier attempt.
    
    But I get errors as follows from the the DTR log file:
    
    "Find current with time stamp between DATE1_hold and DATE2_hold, 0 
    records found"
    
    hence no Hourly utilisation graph.
    
    The recording interval that I used was 14-jul-1992 18:20 until 18-jul-1992
    06:00 (at 15min intervals) and I exported from 15-jul-1992 01:00 until
    15-jul-1992 03:00. In Mcc Reports I entered in the same dates and hours
    as the exporting period.
    
    
    When I experimented in Mcc Reports with a period 14-jul-1992 01:00
    until 14-jul-1992 03:00, I got the following error.
    
    63 records found BUT
    
    Graph-W-...   The data contains all zeroes.
     
     --------------------------------------------
    
    Can anybody comment on the above and tell me if I am allowed to export
    samples of information, or whether I have to export exactly the
    interval specified. 
    
    Also, if older .SNP files remain relating to previous attempts, will
    these complicate matters and should they be deleted.
    
    
    regards Michael Hoare @hhl (London TCC) 
    
     
    
    
    
    
    
    
    15min intervals)
     

When you ran the reports package and asked for a report did you specify a
node NAME or node NUMBER??? For DECnet phase_iv (if that's what you're working
with) needs the NODE NUMBER when cutting a report.

regards,
brad...