Conference azur::mcc

3102.0. "TSAM command parse problem" by ANOSWS::COMFORT (Spent a little time on the hill) Fri May 29 1992 15:18

            <<< NOTED::DISK$NOTES4:[NOTES$LIBRARY_4OF5]MCC.NOTE;3 >>>
                 -< DECmcc Network Management Product Family >-
================================================================================
Note 3102.0                                                           No replies
ANOSWS::COMFORT "Spent a little time on the hill"    25 lines  29-MAY-1992 11:16
--------------------------------------------------------------------------------

    
    Hi,
    
    I have MCC V1.2.7 and TSAM 1.0 installed and when I try to access
    the counter "Current Active Users", I get:
    
    %MCC-I-NOPARCMD, current active users
                     ^                     
    %MCC-I-SYNTAXERR, Syntax error -- unable to interpret remainder
    of line
    %MCC-W-ATTRAMBIG, attribute CURRENT is ambiguous; enter more characters
                                                                   
    However other counters, such as "High Active Users" there is no
    problem.  Likewise rule creation fails on that counter with:
    
    Valid attribute expression was not found.
    
    And then the alarm FM gets hung in a loop until CTRL-C.
    
    And now that I have tried the same with other counter of the "current"
    type, all fail with the same message.
    
    Regards,
    
    Dave Comfort
    

This bug has already been described in note 3032.  We're working it...

Thanks for the report.

-Dave