Conference azur::mcc

2983.0. "Cannot register PhaseV nodes" by RDGENG::PRATT () Tue May 12 1992 17:39

Running Ultrix T1.2.7 DNU T5.1-5

When trying to register phaseV routers (either DECnis's or WANrouters) I get the
following failure...

# manage
DECmcc (T1.2.7)

MCC> register node .reo.reotn1 synonym reotn1

Node LOCAL_NS:.reo.reotn1
AT 1992-05-12-18:24:29.916

Partial registration success. Please retry later to complete the registration.
        Reason for Partial Registration = Communication with the target has
                                          been interrupted
                  Entity Existence Info = Entity Exists
MCC> show node .reo.reotn1 rout circ * all status

Node LOCAL_NS:.reo.reotn1 Routing Circuit *
AT 1992-05-12-18:25:29.885 Status

Insufficient information, entity has only been partially registered
MCC> show node reotn1 rout circ * all status

Node LOCAL_NS:.reotn1 Routing Circuit *
AT 1992-05-12-18:26:18.279 Status

Communication with the target has been interrupted
                   Entity Existence Info = Entity Exists
MCC>
Stopped
# ncl
ncl> show node reotn1 routing circuit * all stat

Node reotn1 Routing Circuit syn-0-0
AT 1992-05-12-19:27:07.710+01:00Iinf

Status

    UID                               = 4AF00140-2FFF-11CB-8640-08002B0AC91B
    State                             = On
    Data Link SDU Size                = 1492
    Point To Point ID                 = '08002B20055002'H
    Data Link Port                    = HDLC Port $0


_______

Node reotn1 Routing Circuit csmacd-0
AT 1992-05-12-19:27:08.190+01:00Iinf

Status

    UID                               = 4B3324C0-2FFF-11CB-8640-08002B0AC91B
    State                             = On
    Data Link SDU Size                = 1492
    LAN L1 ID                         = '08002B20080001'H
    Data Link Port                    = CSMA-CD Port $PORT_01
    L1 Designated Router              = 08-00-2b-20-08-00
    PhaseIV Designated Router         = 08-00-2b-20-08-00


_______
ncl>

As you can see, I can access the router from NCL without any problems. It 
doesn't apply to all my phaseV routers as I have been able to register some
successfully, but once in this state I have never been able to properly register
the node in question. I also had this problem with T1.2.4.

I can register the same nodes successfully using the VMS MCC.

Any ideas?

Ian Pratt

    I'll try to take a look at this sometime tomorrow.