Conference noted::bicycle

299.0. "Suzue Sealed-Tech hubs?" by JACUZI::DESHARNAIS () Wed May 06 1987 03:22

    After giving my bike a good wash last weekend, I noticed a strange
    grinding noise coming from the rear hub.  I seems that water may
    have worked its way into the bearing and caused some problems.
    
    The wheel is a Suzue "Sealed_Tech".  Does anyone know anything about
    this type of hub?  I am curious as to whether this is a sealed bearing
    hub and, if so, if I can repair it myself.  
    
    I plan on getting a free wheel removal tool, but don't know if I'll
    be able to get the hub apart after the free wheel is taken off.
    Are other special tools required for this type of hub?  I have a
    good workshop manual (Bicycling's) but it doesn't say much about
    servicing sealed hubs.
         
    All inputs will be most welcome!
    
    Thanks,
    Denis 

>    The wheel is a Suzue "Sealed_Tech". I am curious as to whether this is 
> a sealed bearing hub and, if so, if I can repair it myself.  
> I plan on getting a free wheel removal tool, but don't know if I'll
> be able to get the hub apart after the free wheel is taken off.

	I think it is only a "Sealed Mechanism" hub.  The bearings
	are conventional but there is a plastic contact seal between
	the cones and the dust covers.  The hubs are serviced the same
	as a conventional hub but you must be careful not to damage
	the seals if you want to pry off the dust covers.

				-John Wasser

	P.S.  I had a "Sealed Mechanism" hub with a cone failure.  When
	I replaced the cone the new one was a smaller diameter so the
	seal didn't seal any more.  I have since replaced the hubs with
	real sealed bearing hubs.